Digital ID View 960H Series Manual de instrucciones descargar pdf (Pagina 55)

4.4.4. Notification

Remote Notify

The system can notify an alarm message to the IP address of Advanced Client Software over the network.

User can choose various different kinds of alarms by pressing “ADD” for such as Log-in/Out, System start, Sensor, Video

loss, Recording failure, Setup, Shutdown, Motion alarm, S.M.A.R.T., and HDD full.

Up to 5 message recipients are allowed.

Note

Configuration first priority is always given to “SCHEDULE” of the “RECORD” menu.

Thus, the system will not send alarm message upon motion alarm or sensor even though user ticks the

check-box of above event selection, unless user sets the “SCHEDULE” in the “RECORD” menu and

“MOTION”/”SENSOR” in the “DEVICE” accordingly.

For example, If user sets just “Continuous” only in “SCHEUDLE” of the “RECORD” menu and ticks the “All”

check-box in “REMOTE NOTIFY”, then the system will not send alarm messages. In this case, user has to set

“CONT + MOT”, “MOTION”, “SENSOR”, or “CON + SENS” to enable REMOTE NOTIFY to function properly.

Note

Users can set remote pop-up in Advanced Client Software (ACS) and Central Management System (CMS)

upon alarm trigger in DVR.

In order for an ACS user to receive an instant pop-up video over network from DVR, a DVR user has to tick

“SENSOR” or “MOTION ALARM” in above menu.

“SENSOR” means the alarm triggered by physical alarm, while “MOTION ALARM” means the alarm triggered

by motion detection.

E-Mail Notify

The system can send notification to an Email address or Advanced Client Software and Central Management System over

the network. Users can choose various different kinds of alarms by pressing “ADD” for such as Log-in/Out,

System start, Sensor, Video loss, Recording failure, Setup, Shutdown, Motion alarm, S.M.A.R.T., and HDD full.

Up to 5 email recipients can be defined.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 64 65

Sin comentarios

Digital ID View 960H Series Manual de instrucciones Pagina 55